6736 Plastic Dispensing Gun 2X101
This is the tool used to make dots, stripes, and spider web designs on plastic baits. The gun comes with one 4 cavity mold for making colored plastic sticks. Insert plastic stick through the inlet tube as far as possible. Plug in the gun. It heats in approximately three minutes. Press gun against cavity in mold. A light pressure with your thumb against the plastic stick is all that is needed to dispense a small amount of plastic for a stripe or dot. Put designs on all your plastic bodies. This gun is also used to make small tails and bodies that are hard to pour by hand. Kit includes: dispensing gun, 4 cavity molds, push stick and instructions
Each
Ratings & Reviews
1 review
4/7/2023 9:11 pm
Gimmic?
by Ave
Is there a special glue stick to be used with this? Not much info there. Hot glue is stiff so is there a soft plastics stick?